Arrow Fastener T50RED Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 4)

BACK TO

INDEX

HOW TO DETERMINE PROPER STAPLE LEG SIZE

In choosing the proper staple leg length for a job there are two basic things

to consider:

1. Thickness of material to be stapled.

2. Hardness of the wood.

As a general rule, in hardwood, approximately 3/16" to 1/4" penetration

into the wood is sufficient...and for softwood – up to approximately 3/8"

should be sufficient. However, if the staple used “stands away” from the

work – this means that too long a leg length has been used. In that case

we recommend the next shorter leg length for desired results.

STAPLE PENETRATION

The T50R.E.D.™ has a hi/low power setting to help drive staples and brad nails into hard and soft materials. For best penetration press

down on the front end with the palm of your hand to prevent recoil when operating.

NAIL PENETRATION

The T50R.E.D.™ shoots a 5/8" (15mm), 3/4" (20mm) and 1" (25mm) brad nails. For best penetration, hold the gun flat against the surface.

Do not tilt or raise the gun.

A WORD ABOUT ARROW

STAPLES & NAILS

Only Arrow

knows the proper staple and nail tolerances required for best performance of the T50R.E.D.™ Staple + Nail Gun. Only Genuine

Arrow

T50

staples and Arrow

nails are made to these exact tolerances to insure top fastening performance. Accept no substitutes. Always

insist on Genuine Arrow

Staples and Nails.

ABOUT STAPLES AND NAILS

1 2 3 4 5 6 7 8 9 ... 12 13

Keine Kommentare

Arrow Fastener T50RED Gebrauchs- und Pflegehandbuch Seite 4